LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Electronically Controlled AWD - With Diagnostics) >> Troubleshooting >> Diagnostic Trouble Code Procedures >> Code No. C1613: Drive Mode Selector Stuck >> Diagnosis

Code No. C1613: Drive Mode Selector Stuck: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. STEP 1. Scan tool (M.U.T.-III) data list 

    Check the following data list (Refer to DATA LIST REFERENCE TABLE  ).

    • Item No.41: Mode SW

    Q: Is the check result normal? 

    1. YES:  Go to  Step 4.
    2. NO:  Go to Step 2.
  2. STEP 2. Check the wiring harness between drive mode selector connector and AWD-ECU connector terminal sw-1. 

    Check the output line for short circuit.

    Q: Is the check result normal? 

    1. YES:  Go to Step 3.
    2. NO:  Repair the defective connector or the wiring harness.
  3. STEP 3. Drive mode selector inspection 

    Refer to DRIVE MODE SELECTOR  .

    Q: Is the check result normal? 

    1. YES:  Go to Step 4.
    2. NO:  Replace the AWD switch (Refer to AWD-ECU  ). Then go to  Step 5.
  4. STEP 4. Check whether the DTC is stored again. 

    Q: Is DTC No. C1613 stored? 

    1. YES:  Replace the AWD-ECU (Refer to AWD-ECU  ). Then go to Step 5.
    2. NO:  Intermittent malfunction (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).
  5. STEP 5. Check whether the DTC is stored again. 

    Q: Is DTC No. C1613 stored? 

    1. YES:  Return to  Step 1.
    2. NO:  This diagnosis is complete.
scientia non olet · About LEMON Manuals