LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Electronically Controlled AWD - With Diagnostics) >> Troubleshooting >> Diagnostic Trouble Code Procedures >> Code No. C1219: Steering Wheel Sensor Signal >> Notes

Code No. C1219: Steering Wheel Sensor Signal: Notes

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • If there is any problem in the CAN bus lines, an incorrect DTC may be stored. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
  • When the steering wheel sensor is replaced, calibrate the steering wheel sensor (Refer to STEERING WHEEL SENSOR CALIBRATION ), and reset the steering wheel sensor correction amount stored in the AWD-ECU. (Item No. 1: SAS adjusted value SPECIAL FUNCTION  ).
  • When hydraulic unit (integrated with G and yaw rate sensor) is replaced, calibrate G and yaw rate sensor (refer to G AND YAW RATE SENSOR CALIBRATION GROUP 35C - On-vehicle Service P.35C-165)
scientia non olet · About LEMON Manuals