Check At Ecu Terminals
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
| No. | Code | Inspection Item | Check condition | Normal condition | |
|---|---|---|---|---|---|
| 1 | SOL+ | Electronic control coupling solenoid (center) | Using scan tool (M.U.T.-III), perform "Test Item No. 4: Control OFF" of "SPECIAL FUNCTION" | 1 V or less | |
| Using scan tool (M.U.T.-III) perform "Test Item No. 6: Center coupling operation check" of "SPECIAL FUNCTION" | Approximately 8 V | ||||
| 3 | 4WDF | Power supply | Always | System voltage | |
| 4 | IG1 | Ignition switch | Ignition switch: ON | System voltage | |
| Ignition switch: OFF | 1 V or less | ||||
| 5 | CANH | CAN-H | - | - | |
| 9 | SOL- | Electronic control coupling solenoid (center) | Always | 1 V or less | |
| 10 | GND1 | Ground | Always | 1 V or less | |
| 13 | CANL | CAN-L | - | - | |
| 16 | SW-1 | Drive mode selector signal | Ignition switch: ON | Drive mode selector: ON | System voltage |
| Drive mode selector: OFF | 1 V or less | ||||