Diagnostic Trouble Code Table
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- During diagnosis, a diagnostic trouble code associated with other system may be stored when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for diagnostic trouble code(s). If diagnostic trouble code(s) are stored, erase them all.
- If more than three minutes elapse after the ignition switch is turned ON without starting engine, the electric power steering-ECU may store diagnostic trouble code U0100 as past trouble.
NOTE:
For electric power steering system the power supply may not shut off immediately after the ignition switch is turned "OFF".
DIAGNOSTIC TROUBLE CODE TABLE
| Diagnostic trouble code No. | Diagnostic item |
|---|---|
| C1510 | Torque sensor main |
| C1511 | Torque sensor sub |
| C1512 | Torque sensor main/sub voltage |
| C1513 | Torque sensor power supply |
| C1514 | Torque sensor power supply too low |
| C1521 | Motor turning angle (output) |
| C1522 | Motor turning angle range |
| C1530 | Motor FET driver |
| C1531 | Motor current too low |
| C1532 | Motor output current too large |
| C1533 | Motor terminal initial voltage |
| C1534 | Motor terminal monitor voltage |
| C1535 | Motor output current |
| C1536 | Motor terminal voltage too high |
| C1540 | Power supply voltage too high |
| C1541 | Power supply voltage too low |
| C1550 | ECU internal error |
| C1561 | Engine revolution data (CAN) |
| C1564 | Vehicle speed data invalid |
| C1565 | Engine revolution data invalid |
| C1566 | Invalid data received from AWC |
| C1657 | Implausible coding data |
| U0100 | Engine ECU CAN timeout |
| U0114 | AWD-ECU CAN timeout |
| U0141 | ETACS-ECU CAN timeout |
| U1073 | Bus-off |
| U1190 | No receive fault detect signal |
| U1195 | Coding not completed |
| U1197 | Coding data unavailable |