Steering Wheel Play Check
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- With the engine running, position the front wheel in the straight ahead direction.
- Measure the circumferential steering wheel play until the front wheels actually start operating while turning the steering wheel slightly in the left and right directions.
Limit: 30 mm (1.2 inches) or less
- If the steering wheel play exceeds the limit value, check the steering shaft joint or steering linkage for looseness, and replace or repair the faulty components if necessary.
- If the steering wheel play still exceeds the limit value after Step 3 is performed, turn the engine off, position the steering wheel in the straight ahead position, and then apply the force (5 N [1.1 pounds]) in the circumferential direction.
At this time, check if the circumferential steering wheel play is within the standard value.
Standard value: 16.5 mm (0.65 inch) or less
- If the steering wheel play is outside the standard value after Step 4 is performed, remove the steering gear and linkage, and check and adjust the pinion total rotation torque (Refer to REMOVAL AND INSTALLATION ).