LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Supplemental Restraint System (SRS) -- Lancer Evolution) >> SRS Control Unit (SRS-Ecu) >> Removal And Installation >> Installation Service Points >> >> C << Post-Installation Inspection

>> C << Post-Installation Inspection

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Reconnect the negative (-) battery cable.
  2. Turn the ignition switch to the "ON" position.
  3. Does the "SRS" warning light illuminate for approximately seven seconds, and then go out?
  4. If yes, the SRS system is functioning properly. If not, refer to DIAGNOSTIC TROUBLE CODE CHART < SRS-ECU >  .
    Fig 1: Identifying SRS Warning Light
    G05396576Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.