LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Supplemental Restraint System (SRS) -- Lancer Evolution) >> SRS Air Bag Diagnosis >> Data List Reference Table >> Data List Output

Data List Output

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

The following items can be read by the scan tool from the SRS-ECU input data.

DATA LIST REFERENCE CHART

Item No. Display on M.U.T.-III Check conditions Normal conditions
01 SRS warning light "ON" request
  • Ignition switch: ON
  • After warning lamp pre-check
 OFF
  • Ignition switch: ON
  • During warning lamp pre-check
 ON
02 Pass. SRS light "ON" request
  • Ignition switch: ON
  • After warning light pre-check
 OFF
  • Ignition switch: ON
  • During warning light pre-check
 ON
04 Passenger's seatbelt switch
  • Ignition switch: ON
  • After warning light pre-check
  • Wear the passenger seatbelt.
 Fastened
  • Ignition switch: ON
  • After warning light pre-check
  • Undo the passenger seatbelt.
 Unfastened
05 Passenger seat air bag ignition
  • Ignition switch: ON
  • After warning light pre-check
  • Apply a load to the passenger seat.
 Permission
  • Ignition switch: ON
  • After warning light pre-check
  • Undo a load from a passenger seat.
 Prohibition

The following items can be read by the scan tool from the occupant classification-ECU input data.

DATA LIST REFERENCE CHART

Item No. Display on M.U.T.-III Check condition Normal condition
01 Passenger weight Apply a load to the passenger seat. Load equivalent to passenger seat crew member load
02 Dr seat position sensor current Slide the seat the back-end to the front-position. 0 to 1,700 mA
03 Dr seat position sensor voltage Slide the seat the back-end to the front-position. 0 to 5,000 mV
07 Dr seat position sensor status Slide the seat the back-end to the front-position. Not in Frontal Zone/In Frontal Zone/Undetermined
08 occupant classification status Apply a load to the passenger seat. Empty/RFIS/Child/More 5th%/Undermined
10 Battery voltage Always 6.5 to 16 V
21 Pa seat weight sensor 1 RR Apply a load to the passenger seat. Load equivalent to passenger seat crew member load
22 Pa seat weight sensor 1 RR volt Apply a load to the passenger seat. 0 to 5,000 mV
23 Pa seat weight sensor 2 RF Apply a load to the passenger seat. Load equivalent to passenger seat crew member load
24 Pa seat weight sensor 2 RF volt Apply a load to the passenger seat. 0 to 5,000 mV
25 Pa seat weight sensor 3 LF Apply a load to the passenger seat. Load equivalent to passenger seat crew member load
26 Pa seat weight sensor 3 LF volt Apply a load to the passenger seat. 0 to 5,000 mV
27 Pa seat weight sensor 4 LR Apply a load to the passenger seat. Load equivalent to passenger seat crew member load
28 Pa seat weight sensor 4 LR volt Apply a load to the passenger seat. 0 to 5,000 mV
30 VIN Information Always -
scientia non olet · About LEMON Manuals