LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Active Stability Control System (ASC) - With Diagnostics) >> On-Vehicle Service >> Hydraulic Unit (HU) Check >> Hydraulic unit installation adjustment

Hydraulic unit installation adjustment

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Operate the pre-removal steps for the hydraulic unit. (Refer to << A >> ASC-ECU HARNESS CONNECTOR DISCONNECTION  .)
  2. Remove all brake tubes.
  3. Loosen the mounting bolt and nut of the hydraulic unit bracket.
  4. Install all brake tubes temporarily.
  5. Shake hydraulic unit to all directions with both hands to make the hydraulic unit bracket insulator fit with the unit.
  6. Install the hydraulic unit bracket with mounting bolt and nut not to load the brake tube.
  7. Install all brake tubes securely.
    NOTE: Install the flare nut taking care not to let the brake tube turn together.
  8. Operate the post-installation steps of the hydraulic unit. (Refer to << A >> ASC-ECU HARNESS CONNECTOR DISCONNECTION  .)
scientia non olet · About LEMON Manuals