How To Perform Actuator Test
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
Required Special Tools:
- MB992744: Vehicle communication interface-Line (V.C.I.-Line)
- MB992745: V.C.I.-Line main harness A (for vehicle with CAN communication)
- MB992747: V.C.I.-Line USB cable short
- MB992748: V.C.I.-Line USB cable long
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)
CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
- Connect the scan tool MB991958 to the data link connector.
- Turn the ignition switch to the "ON" position.
- Select "System Select."
- Select "ABS/ASC/ASTC" from "System List," and press the "OK" button.
- Choose "Actuator Test" from "ABS/ASC/ASTC" screen.
- Choose an appropriate item and select the "OK" button.