Check Chart For Diagnostic Trouble Codes Table
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC TROUBLE CODES TABLE
| Code No. | Diagnosis item |
|---|---|
| C1394 | Incompleted learn neutral (Steering wheel sensor) |
| C1707 | Implausible coding data |
| C1750 | ACC/FCM-ECU voltage out of range |
| C1751 | ACC/FCM-ECU failure |
| C1752 | ACC/FCM radar temperature out of range |
| C1753 | ACC/FCM radar blockage detected |
| C1754 | ACC/FCM radar calibration not completed |
| C1768 | Alignment left compensation |
| C1769 | Alignment right compensation |
| C1770 | Reflector plate in the lowermost |
| C1771 | Reflector plate in the uppermost |
| C1772 | Alignment sensor too far right |
| C1773 | Alignment sensor too far left |
| C1774 | Alignment sensor too low |
| C1775 | Alignment sensor too high |
| C1776 | Received ACC failure from engine control module |
| C1777 | Received ACC failure from ASC-ECU |
| C1778 | Vehicle speed signal failure |
| C1779 | Brake master pressure signal failure |
| C1780 | A basis signal failure |
| C1781 | SAS failure |
| C1782 | SAS signal failure |
| C1783 | ACC distance switch fixed ON |
| C1784 | FCM switch fixed ON GROUP 35C - Troubleshooting P.35C-108 |
| C1785 | Fault detection signal failure |
| C1786 | Received limp home from transaxle control module |
| U0100 | Engine CAN timeout |
| U0101 | T/M CAN timeout |
| U0121 | ABS/ASC CAN timeout |
| U0126 | SAS CAN timeout |
| U0141 | ETACS CAN timeout |
| U1195 | Coding not completed |