Inspection Procedure 15: Engine stall: Diagnosis
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- STEP 1. Check the engine performance.
Q: Is the check result normal?
- YES: Go to Step 2.
- NO: Repair the failure, and perform adjustment.
- STEP 2. Check the transmission fluid.
Check the transmission fluid for burning, fouling, and foreign material.
Q: Is the check result normal?
- YES: Go to Step 3.
- NO: Go to Step 6.
- STEP 3. Check the transmission fluid level.
Check if the transmission fluid level is adequate.
Q: Is the check result normal?
- YES: Go to Step 4.
- NO: Check and repair the leakage point of the transmission fluid, add the transmission fluid, and then go to Step 4.
- STEP 4. Perform a hydraulic test.
Refer to HYDRAULIC PRESSURE TESTS .
Q: Is the check result normal?
- YES: Go to Step 5.
- NO: Go to Step 6.
- STEP 5. Compare with another same model vehicle.
Q: Is there a difference from the same model vehicle?
- YES: Go to Step 6.
- NO: The procedure is complete.
- STEP 6. Retest the system.
Does the engine stall occur again?
Q: Is the check result normal?
- YES: Replace the transaxle assembly.
- NO: The procedure is complete.