DTC P0893: Interlock Detection: Diagnosis
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- STEP 1. Check the DTC.
Check if the following DTCs are stored.
- P0720 Output shaft speed sensor
- P0846 2-6 brake pressure switch
- P0876 High clutch pressure switch
- P0962 Line pressure linear solenoid valve system < Short circuit >
- P0963: Line pressure linear solenoid valve system < Open circuit >
- P0973 Low clutch linear solenoid valve system < Short circuit >
- P0974 Low clutch linear solenoid valve system < Open circuit >
- P0976: 2-6 brake linear solenoid valve system < Short circuit >
- P0977: 2-6 brake linear solenoid valve system < Open circuit >
- P0979 3-5 reverse clutch linear solenoid valve system < Short circuit >
- P0980 3-5 reverse clutch linear solenoid valve system < Open circuit >
- P0982: High clutch linear solenoid valve system < Short circuit >
- P0983: High clutch linear solenoid valve system < Open circuit >
- P0988 Low-reverse brake pressure switch
- P0998: Low clutch shift solenoid valve system < Short circuit >
- P0999: Low clutch shift solenoid valve system < Open circuit >
- P099B Low-reverse brake shift solenoid valve system < Short circuit >
- P099C Low-reverse brake shift solenoid valve system < Open circuit >
- P2763 Lock-up and Low-reverse brake linear solenoid valve system < Short circuit >
- P2764 Lock-up and Low-reverse brake linear solenoid valve system < Open circuit >
Q: Is the check result normal?
- YES: Go to Step 2.
- NO: Repair or replace the failure section.
- STEP 2. Check TCM related to the solenoid, pressure switch and output shaft speed sensor, the A/T control solenoid valve assembly connector pin terminals, and the connection status.
Q: Is the check result normal?
- YES: Replace the TCM, and then go to Step 3.
- NO: Repair or replace the failure section.
- STEP 3. Erase the DTC, and drive the vehicle for a while.
Check that the normal code is displayed.
Q: Is the check result normal?
- YES: The procedure is complete.
- NO: Replace the transaxle assembly.