LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic Transaxle On-Vehicle Service - With Diagnostics) >> Automatic Transaxle Diagnosis < A/T > >> Check At Engine TCM Terminal

Check At Engine TCM Terminal

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Engine TCM Terminal
G09665252Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Terminal No. Terminal code Inspection item Inspection requirement Normal condition
1 HCLS High clutch linear solenoid valve While driving At high clutch engaged 1 V or less
Other than above 300 Hz(1)
2 35LS 3-5 reverse clutch linear solenoid valve While driving At 3-5 reverse clutch engaged 1 V or less
Other than above 300 Hz(1)
3 26LS 2-6 brake linear solenoid valve While driving At 2-6 brake engaged 300 Hz(1)
Other than above 1 V or less
6 INHP Transmission range switch: P Ignition switch: ON Selector lever position: P Battery positive voltage
Other than above 1 V or less
7 INHR Transmission range switch: R Ignition switch: ON Selector lever position: R Battery positive voltage
Other than above 1 V or less
8 INHD Transmission range switch: D Ignition switch: ON Selector lever position: D Battery positive voltage
Other than above 1 V or less
9 PDUP Paddle shift switch (up) Ignition switch: ON Paddle shift lever position: Upshift and hold 1 V or less
Paddle shift lever position: Other than above Battery positive voltage
10 CAH1 CAN_H - -
11 CAL1 CAN_L - -
12 VIG1 Power supply Ignition switch: ON Battery positive voltage
Ignition switch: OFF 1 V or less
13 GND1 Ground Always 1 V or less
14 LCSS Low clutch linear solenoid valve While driving Gear range: 5th or 6th Battery positive voltage
Other than above 1 V or less
21 INHN Transmission range switch: N Ignition switch: ON Selector lever position: N Battery positive voltage
Selector lever position: Other than above 1V or less
22 INHL Transmission range switch: L Ignition switch: ON Selector lever position: L Battery positive voltage
Selector lever position: Other than above 1V or less
25 VIG2 Power supply Ignition switch: ON Battery positive voltage
Ignition switch: OFF 1 V or less
26 GND2 Ground Always 1 V or less
31 BATT Battery back up Always Battery positive voltage
32 PDDW Paddle shift switch (down) Ignition switch: ON Paddle shift lever position: Downshift and hold 1 V or less
Paddle shift lever position: Other than above Battery positive voltage
37 PGB1 Output shaft speed sensor Vehicle speed: 30 km/h (18.6 mph) Approx. 588 Hz
38 PGA1 Input shaft speed sensor Engine speed: 700 r/min Approx. 353 Hz
39 O/TS Transmission fluid temperature sensor Ignition switch: ON Transmission fluid temperature: 20°C (68°F) Approx. 2.53 V
Transmission fluid temperature: 80°C (176°F) Approx. 0.69 V
40 PLLS Line pressure linear solenoid valve Ignition switch: ON While driving Approx. 300 Hz(1)
Other than above 1 V or less
41 LOLS Low clutch linear solenoid valve While driving At low clutch engaged Approx. 300 Hz(1)
Other than above 1 V or less
43 LRPS Low-reverse brake pressure switch While driving At low-reverse brake engaged 1 V or less
Other than above Battery positive voltage
44 26PS 2-6 brake pressure switch While driving At 2-6 brake engaged 1 V or less
Other than above Battery positive voltage
45 HCPS High clutch pressure switch While driving At high clutch engaged 1 V or less
Other than above Battery positive voltage
48 PGB-- Output shaft speed sensor ground Always 1 V or less
49 PGA-- Input shaft speed sensor ground Always 1 V or less
50 O/T-- Transmission fluid temperature sensor ground Ignition switch: ON 1 V or less
51 LRSS Low-reverse brake shift solenoid valve While driving Battery positive voltage
Other than above 1 V or less
52 LULS Lock-up and Low-reverse brake liner solenoid Ignition switch: ON At lock-up engaged Approx. 300 Hz(1)
Other than above 1 V or less
(1) The operation is performed at 300 Hz in a voltage range of 0 to 12 V when measured by an oscilloscope.