<< B >> Piston Pin Removal

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Special tool Piston pin setting tool (MD998780) consists of parts shown in the illustration. Use also special tool Guide D (MB991659) to remove the piston pin.

Fig 1: Identifying Piston Pin Setting Tool (MD998780)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Insert the push rod into the piston pin from the front mark side of the piston top surface, and attach special tool Guide D (MB991659).
Set the piston and connecting rod assembly on the base so that the front mark of the piston faces upward.
Use a press to push the push rod and pull out the piston pin.
NOTE: After pulling out the piston pin, organize pistons, piston pins and connecting rods by cylinder No.

Fig 2: Inserting Push Rod Into Piston Pin
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.