LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Engine Overhaul - 2.4L) >> Oil Pan And Timing Chain Case >> Removal And Installation >> Installation Service Points >> >> D << Oil Pan Installation

>> D << Oil Pan Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Completely remove liquid gasket adhering to the cylinder block and oil pan.
    CAUTION: Install the oil pan within three minutes after liquid gasket is applied.
  2. Apply liquid gasket of ø2.5 ± 0.5 mm (0.10 ± 0.02 inch) of thickness in diameter to the illustrated area of the oil pan.

    Specified sealant: 

    ThreeBond 1217G or equivalent 

  3. Tighten the oil pan to the specified torque of 10 ± 2 N.m (89 ± 17 in-lb) (M6) and 31 ± 2 N.m (23 ± 1 ft-lb)(M8).
    Fig 1: Identifying Oil Pan Liquid Gasket Applying Area
    G09663493Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals