>> A << Engine Oil Pressure Switch Installation
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Completely remove sealant adhering to the oil pressure switch and cylinder block threaded holes.CAUTION: Do not allow sealant to squeeze out to the screw tip.
- Apply sealant of 5 mm to the threaded portion of the oil pressure switch shown in the illustration.
Specified sealant:
ThreeBond 1141J or equivalent
CAUTION: Do not tighten, exceeding the specified torque. - Tighten the oil pressure switch to the cylinder block to the specified torque of 10 ± 2 N.m (124 ± 17 in-lb).