Replacement Procedure Of Valve Guide
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Pull out the valve guide with a press toward the cylinder block side.CAUTION: Do not use a valve guide with the same size as that of the pulled out valve guide because it cannot be press fitted.
- Ream the valve guide hole of the cylinder head to match it with the diameter of the oversize valve guide to be press fitted.
Valve guide bore diameter 0.25 O.S.: 11.23 - 11.25 mm (0.4422 - 0.4429 inch)
- Press fit the valve guide to the illustrated dimension.
Standard value Inlet side: 15.1 - 15.7 mm (0.60 - 0.61 inch) Exhaust side: 19.7 - 20.3 mm (0.78 - 0.79 inch)
NOTE: Press fit the valve guide from the cylinder head top surface. - After pressing fit the valve guide, insert a new valve to check for sliding.