Cylinder Head
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Check the cylinder head for water leakage, gas leakage, damage or cracks before cleaning.
- Completely remove oil, scale, sealant, carbon, etc. After cleaning oil passages, blow air to make sure that they are not clogged.CAUTION: The grinding limit shall be within 0.2 mm (0.008 inch) in combination with the cylinder block to be assembled.
- For the flatness on the cylinder head bottom, measure distortion using a straight edge and free gauge. If the distortion exceeds the limit, grind and repair it.
Distortion on bottom Standard value: Within 0.05 mm (0.002 inch) Limit: 0.2 mm (0.008 inch) Grinding limit: 0.2 mm (0.008 inch)
Cylinder head height: 112.0 mm (44.1 inch)