>> D << Crankshaft Bearing Lower Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

When replacing the crankshaft bearing lower, select a bearing with the size corresponding to the crankshaft journal diameter in the table below.

Crankshaft		Crankshaft bearing
Identification mark	Journal diameter mm (in)	Identification mark
0	51.985 - 51.988 (2.0467 - 2.0468)	0
1	51.982 - 51.985 (2.0465 - 2.0467)	1

Crankshaft		Crankshaft bearing
Identification mark	Journal diameter mm (in)	Identification mark
2	51.979 - 51.982 (2.0464 - 2.0465)	2
3	51.976 - 51.979 (2.0463 - 2.0464)	3
4	51.973 - 51.976 (2.0462 - 2.0463)	4

An identification mark of a crankshaft is stamped at the illustrated position by No.

Fig 1: Identifying Journal Identification Mark Position
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
The crankshaft bearing lower has an identification mark at the illustrated position.
Install the selected crankshaft bearing lower.

Fig 2: Identifying Crankshaft Bearing Identification Mark
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.