>> C << Crankshaft Bearing Upper Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

When replacing the crankshaft bearing upper, select a bearing with the size corresponding to the cylinder block journal diameter in the table below.

Cylinder block		Crankshaft bearing
Identification mark	Journal diameter mm (in)	Identification mark
1	56.000 - 56.006 (2.2048 - 2.2049)	1
2	56.006 - 56.012 (2.2050 - 2.2051	2
3	56.012 - 56.018 (2.2052 - 2.2054)	3

An identification mark of a cylinder block is stamped at the illustrated position by No.

Fig 1: Identifying Cylinder Block Identification Mark
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
The crankshaft bearing upper has an identification mark at the illustrated position.
Install the selected crankshaft bearing upper.

Fig 2: Identifying Crankshaft Bearing Groove And Identification Mark
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.