>> E << Drive Plate Bolt Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Clean off sealant and oil of thread of crankshaft and drive plate bolts.
Use special tool MB991883 to secure the drive plate.

Fig 1: Identifying Special Tool MB991883
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Apply engine oil to thread of crankshaft and bolt seat area of drive plate.
Apply the sealant to the thread of drive plate bolts.
Specified sealant: Three bond 1324 or equivalent

Fig 2: Identifying Crankshaft Thread Engine Oil Applying Area
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Tighten drive plate bolts to temporary torque of 40 N.m (32 ft-lb) in the order shown to illustration.
Tighten drive plate bolts to specified torque of 130 N.m (95 ft-lb) in the order shown in the illustration.

Fig 3: Drive Plate Bolt Tightening Sequence
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.