LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Engine Overhaul - 2.4L) >> Balancer Chain >> Removal And Installation >> Installation Service Points >> >> C << Balancer Shaft Chain TENSIONER Installation

>> C << Balancer Shaft Chain TENSIONER Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the chain tensioner to the ladder frame.
    CAUTION: Install the chain tensioner precisely in place after installing the tensioner lever and chain guide to prevent the plunger of the chain tensioner from jumping out.
  2. Remove the hard wire (piano wire, etc.) of ø1.5 or hexagonal bar wrench (1.5 mm [0.06 inch]) from the tensioner. This enables the plunger of the chain tensioner to push the balancer shaft tensioner lever to keep the balancer shaft chain tight.
    Fig 1: Identifying Balancer Shaft Chain Tensioner
    G09663572Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals