Transfer Oil Change

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine room under cover front B assembly. (Refer to UNDER COVER .)
Remove the oil drain plug and gasket to drain the oil.
Install the oil drain plug and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb)

Fig 1: Identifying Oil Filler Plug, Engine Oil Pan And Oil Drain Plug
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Remove the oil filler plug and gasket, then fill the oil up to the lower edge of the oil filler plug hole.
Brand name: Mitsubishi genuine Dia-Queen LSD Gear Oil

Quantity: 0.9 dm ³ (1.0 quarts)
Install the oil filler plug and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb)
Install the engine room under cover front B assembly. (Refer to UNDER COVER .)

Fig 2: Identifying Filler Plug Hole, Gasket And Oil Filler Plug
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.