<< A >> Wiring Harness Connector Disconnection
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect the following wiring harness connectors:
| Connector number | Connector name |
|---|---|
| D-18 (2) | Power seat connector < Vehicle with power seat > |
| D-19 (4 - black) | Heated seat connector (LH) < Vehicle with heated seat > |
| D-20 (2 - natural) | Front seat belt switch connector (Driver's side) |
| D-21 (2 - yellow) | Side air bag module (squib) connector (LH) < Vehicles with side-airbag > |
| D-22 (2 - yellow) | Side air bag module (squib) connector (RH) < Vehicles with side-airbag > |
| D-23 (2 - natural) | Front seat belt switch connector (Passenger's side) |
| D-24 (4 - black) | Heated seat connector (RH) < Vehicle with heated seat > |
| D-37 (2 - gray) | Seat slide sensor connector (Driver's side) |
| D-38 (4 - black) | Front seat assembly connector (Passenger's side) (occupant classification-ECU) |
NOTE:
When disconnecting the side air bag module connectors of D-21 and D-22, unlock the connector by sliding the locking button to the direction of the arrow as shown in the figure, and then disconnect the connector.