LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Basic Brake System) >> Rear Disc Brake Assembly >> Removal And Installation >> Installation Service Point >> >> A << Brake Hose Installation

>> A << Brake Hose Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pass the brake hose through the hole in the bracket.
  2. Install the brake hose to the brake caliper.
  3. Install the brake hose at the two fixing points.
  4. Twist the brake hose toward the lesser torsion between the brake hose and bracket as shown in the figure, and fix it to the body-side bracket with a clip.
    Fig 1: Installing Brake Hose To Brake Caliper
    G09667584Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals