INSPECTION PROCEDURE 6: Squealing, Groaning or Chattering Noise when Brakes are Applied: Diagnosis
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- STEP 1. Check the brake disc and pads for wear or cutting.
Q: Is there wear or cutting?
- YES: Repair or replace the part. Then go to Step 4.
- NO: Go to Step 2.
- STEP 2. Check the calipers for rust.
Q: Is there any rust?
- YES: Remove the rust. Then go to Step 4.
- NO: Go to Step 3.
- STEP 3. Adjust the brake pedal.
Refer to BRAKE PEDAL INSPECTION .
Q: Is the brake pedal adjusted correctly?
- YES: Go to Step 4.
- NO: Adjust the brake pedal. Then go to Step 4.
- STEP 4. Recheck symptom.
Q: Is the symptom eliminated?
- YES: The procedure is complete.
- NO: Start over at step 1. If a new symptom surfaces, refer to the SYMPTOM CHART .