LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Engine Mechanical - 3.0L) >> Oil Pan And Oil Strainer >> Removal And Installation >> Installation Service Points >> >> B << Engine Lower Oil Pan Installation

>> B << Engine Lower Oil Pan Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove sealant from the engine lower oil pan and engine upper oil pan.
  2. Degrease the sealant-coated surface and the engine lower oil pan mating surface.
  3. Apply a bead of the sealant to the mating surface of the engine lower oil pan as shown.

    Specified sealant: ThreeBond 1227D or equivalent 

    NOTE: Install the engine lower oil pan immediately after applying sealant.
  4. Assemble the engine lower oil pan to the engine upper oil pan.
    Fig 1: Identifying Sealant Applying Area On Mating Surface Of Engine Lower Oil Pan
    G09663696Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    CAUTION: After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the engine oil or water to the sealant application area or start the engine.
  5. Install the bolts to the lower oil pan as shown, and tighten them to the specified torque.

    Tightening torque: 9.5 ± 2.5 N.m (85 ± 22 in-lb) 

    Fig 2: Identifying Lower Oil Pan Bolts
    G09663697Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals