LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Engine Mechanical - 3.0L) >> Engine Assembly >> Removal And Installation >> Removal Service Points >> << A >> Fuel High-Pressure Hose Disconnection

<< A >> Fuel High-Pressure Hose Disconnection

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the stopper of the fuel high-pressure hose.
    Fig 1: Removing Out Fuel High-Pressure Hose
    G09663729Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Raise the retainer of the fuel high-pressure hose and pull out the fuel high-pressure hose in the direction shown in the figure.
    NOTE: If the retainer is released, install it securely after removing the fuel high-pressure hose.
    Fig 2: Pulling Out Fuel High-Pressure Hose
    G09663730Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals