LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Engine Mechanical - 2.4L) >> On-Vehicle Service >> Auto-TENSIONER Check >> Operation Check

Operation Check

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Stop the engine from the idle state.
  2. Remove the radiator condenser tank mounting bolt, and move the radiator condenser tank to a place where it does not interfere with the auto-tensioner check (Refer to RADIATOR ).
  3. Check that the drive belt are not protruding from the pulley width of drive belt auto-tensioner.
  4. Remove the drive belt (Refer to << A >> DRIVE BELT REMOVAL  ).
    WARNING: Be sure to set the tool to the hexagonal part securely to prevent the tool from falling off because the tension of the auto-tensioner is high.
  5. Securely set the tool to the hexagonal part of the auto-tensioner.
  6. Check that no binding is present by turning the auto-tensioner in the left and right directions.
  7. If there are any problems in the procedure 2 or 5, replace the drive belt auto-tensioner.
  8. Install the drive belt (Refer to << A >> DRIVE BELT REMOVAL  ).
  9. Install the radiator condenser tank to the original position (Refer to RADIATOR ).
scientia non olet · About LEMON Manuals