LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Intake & Exhaust System) >> Intake Manifold >> Removal And Installation - 2.4L Engine >> Installation Service Points >> >> B << Inlet Manifold Stay Installation

>> B << Inlet Manifold Stay Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Temporarily tighten the inlet manifold stay with mounting bolt.
  2. Make sure that the inlet manifold stay is closely contacted with the installation surface of each part, and then tighten the mounting bolt to the specified torque.

    Tightening torque: 20 ± 2 N.m (15 ± 1 ft-lb). 

scientia non olet · About LEMON Manuals