Trouble Symptom Chart
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
During troubleshooting, a DTC associated with other system may be stored when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTC(s). If DTC(s) are stored, erase them all.
| Trouble symptom | Inspection procedure No. | Reference |
|---|---|---|
| SCAN TOOL (M.U.T.-III) CANNOT COMMUNICATE WITH ETACS-ECU. | 1 | Inspection Procedure 1: Scan tool (M.U.T.-III) cannot communicate with ETACS-ECU |
| THE IGNITION KEY CANNOT BE REGISTERED USING SCAN TOOL (M.U.T.-III). | 2 | Inspection Procedure 2: The ignition key cannot be registered using scan tool (M.U.T.-III) |
| ENGINE DOES NOT START. | 3 | Inspection Procedure 3: Engine does not start |
| CHECK THE POWER SUPPLY AND GROUND CIRCUIT TO THE RECEIVER ANTENNA. | 4 | Inspection Procedure 4: Check the power supply and ground circuit to the receiver antenna |