>> A << Pre-Installation Inspection

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Dispose of side-air bag modules only according to the specified procedure (Refer to PASSENGER'S AIR BAG ON/OFF INDICATOR LIGHT ).

When installing the new side-air bag modules, refer to "INSPECTION " .
Connect the negative (-) battery cable.
CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III) to the data link connector.
Turn the ignition switch to the "ON" position.
Check DTCs using scan tool (M.U.T.-III) to ensure entire SRS operates properly.
WARNING: Wait at least 60 seconds after disconnecting the battery cable before doing any further work (Refer to SERVICE PRECAUTIONS ).

WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
Turn the ignition switch to the "LOCK" (OFF) position. Disconnect the negative (-) battery cable and tape the terminal to prevent accidental connection and air bags deployment.