LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Supplemental Restraint System (SRS) - With Diagnostics) >> Seat Belts With Pre-TENSIONER >> Inspection

Seat Belts With Pre-TENSIONER: Inspection

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Never attempt to measure the circuit resistance of the seat belt pre-tensioner and lap pre-tensioner (squib), even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental air bag deployment will result, and possible serious personal injury.
WARNING:
  • If any component damage is found during the following inspection, replace the seat belt pre-tensioner with a new one. Dispose of the old one according to the specified procedure (Refer to PASSENGER'S AIR BAG ON/OFF INDICATOR LIGHT  ).

If any malfunction is found in the following inspections, replace the seat belt with pre-tensioner with a new one.

  1. Check the seat belt pre-tensioner and lap pre-tensioner for dents, cracks or deformation.
  2. Check the harness and connector for damage and the terminal for deformation.
scientia non olet · About LEMON Manuals