DIAGNOSTIC TROUBLE CODE TABLE < Occupant classification-ECU >
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
During diagnosis, a diagnostic trouble code associated with another system may be stored when the electric motor switch is turned "ON" position with connector(s) disconnected. After completing the repair, confirm all systems for diagnostic trouble code(s). If diagnostic trouble code(s) are stored, erase them all.
Inspect according to the inspection chart that is appropriate for the DTC.
DIAGNOSTIC TROUBLE CODE TABLE < OCCUPANT CLASSIFICATION-ECU >
| Diagnostic trouble Code No. | Inspection item |
|---|---|
| B1690 | Electromagnetic Interference |
| B1691 | Occupant Sensing Antenna |
| B1693 | Occupant Sensing Antenna Open |
| B1694 | Occupant Sensing ANT.SHT to GND |
| B1695 | Occupant Sensing ANT.SHT to BAT |
| B1CB2 | Occupant Classification-ECU Parameter Table Incompatible |
| B210D | Battery Voltage Low |
| B210E | Battery Voltage High |
| B2212 | OCM Internal Error |
| U1109 | ETACS CAN Timeout |
| U1190 | No Receive Fault Detect Signal |
| U15A2 | Vehicle speed Information Lost |
| U15A3 | Odometer Information Lost |
| U15A4 | VIN Information Lost |