<< C >> Passenger's (Front) Air Bag Module Removal

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Never use an electric tester to diagnose the air bag module circuit. Never attempt to disassemble the air bag module.
Be sure to store the removed air bag module in a clean and dry place with a pad surface facing upward.
When discarding the air bag module, discard after deploying the air bag as specified in the service procedure (Refer to PASSENGER'S AIR BAG ON/OFF INDICATOR LIGHT ).

Fig 1: Pulling Out Locking Button Of Wiring Harness Side Connector

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Insert a flat-tipped screwdriver or similar tool to the location shown in the figure. After disengaging the tabs, remove the passenger's (front) air bag module.

Fig 2: Removing Front Passenger's Air Bag Module

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.