LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Supplemental Restraint System (SRS) - With Diagnostics) >> Knee Air Bag Module >> Removal And Installation >> Removal Service Points >> << B >> Knee Air Bag Module Removal

<< B >> Knee Air Bag Module Removal

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Never use an electric tester to diagnose the air bag module circuit. Never attempt to disassemble the air bag module.
  • The removed air bag module should be stored in a clean, dry place.
  • When discarding the air bag module, discard after deploying the air bag as specified in the service procedure (Refer to PASSENGER'S AIR BAG ON/OFF INDICATOR LIGHT  ).

Use the flat-tipped screwdriver to pull out the locking button of wiring harness side connector, and release the lock.

Fig 1: Pulling Out Locking Button Of Wiring Harness Side Connector
G09666781Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals