LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Supplemental Restraint System (SRS) - With Diagnostics) >> Air Bag Module Disposal Procedures >> Knee Air Bag Deployment Outside The Vehicle

Knee Air Bag Deployment Outside The Vehicle

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Deploy the air bag in the wide open, flat place with a distance of 6 m (20 feet) or more from obstacles and people.
  • When deploying the air bag in the open space, do not deploy when the strong wind is blowing. Even with a slight breeze, ignite at the windward of the air bag module.
CAUTION: Disconnect the battery cable connection, and wait for 60 seconds or more before starting the work.
  1. Disconnect the (-) and (+) terminals of battery cable, and then remove the battery from the vehicle.
    CAUTION: When the connector is disconnected, the two pins of air bag module are automatically shorted to prevent the unintentional deployment caused by the static or others. However, in preparation for the accidental deployment, store the air bag module on a flat place with the deployment surface facing upward. Also, do not put anything on it.
  2. Remove the knee air bag module from the vehicle (Refer to KNEE AIR BAG MODULE  ).
  3. Connect the deployment wires of 6 m (20 feet) or more to each of the two wiring harnesses of special tool adapter harness (MB991885), and cover the connection areas with insulation tape. Keep the other ends of deployment wires connected to each other (shorted).
    NOTE: This prevents the unintentional activation of inflator caused by the static or others.
  4. Connect the adapter harness to the knee air bag module.
    Fig 1: Identifying Deployment Wires, Wiring Harnesses And Special Tool Adapter Harness
    G09666838Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Pass the thick wire through the hole of air bag module mounting bracket. When, with the air bag module deployment surface facing upward, fit the module to the old tire with wheel.
    Fig 2: Identifying Knee Air Bag Module And Deployment Wires
    G09666839Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Place three old tires without wheel onto the tire to which the air bag module is fixed.
    Fig 3: Identifying Tires Without Wheels And Deployment Wires
    G09666840Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    CAUTION:
    • Make sure that no one is present near the air bag module before deploying the air bag.
    • Immediately after the air bag deployment, the inflator is extremely hot. Thus, before handling, leave the inflator for 30 minutes or more to cool.
    • If the air bag module does not deploy, consult with your distributor.
    Fig 4: Deploying Air Bag Module
    G09666841Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  7. Disconnect the deployment wire connection at a place as far as possible from the air bag module. Then, connect the wires to the removed vehicle battery to deploy the air bag module.
  8. Discard the deployed air bag module according to the disposal procedures (Refer to AIR BAG MODULE DISPOSAL PROCEDURES ).
scientia non olet · About LEMON Manuals