<< A >> Strut Nut Removal

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Install the spring compressor (special tool: MB991793) to attachment A (special tool: MB991795) as shown in the figure.

Fig 1: Identifying Special Tool (MB991793 And MB991795)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Set the strut assembly to the following special tools.
- Spring compressor (MB991793)
- Attachment A (MB991795)
- Upper plate (MB991794)
- Fixture (MB991830)
  NOTE: Use the bolts and nuts removed from the vehicle to secure the strut assembly and tighten them lightly by hand.
After setting the strut assembly, operate the spring compressor and compress the coil spring by approximately 5 mm.
CAUTION: The lock nut for the piston rod inside the strut may be loose. Do not use the impact wrench to loosen the strut nut.

Fig 2: Identifying Special Tool
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Use the following special tools to loosen the strut nut.
- Wrench (MB991681)
- Socket (MB991682)
Fig 3: Identifying Special Tool (MB991681 And MB991682)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.