>> A << Stabilizer Bar/Bushing/Stabilizer Clamp Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Install the stabilizer clamp at the position shown in the figure, and tighten the stabilizer clamp mounting bolt.

Fig 1: Identifying Stabilizer Clamp Position
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the bushing with the bushing slit directed toward the rear of the vehicle.

Fig 2: Identifying Bushing With Bushing Slit
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.