LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (General (Electrical) -- Lancer Evolution) >> How To Diagnose >> Checking Switches >> Notes

Checking Switches: Notes

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

In a circuit diagram, a switch is shown in the idle state.

  1. Normally open or normally closed switch

    Switches are classified into those which open the circuit and those which close the circuit when off.

    Switches are shown in their normal state unless specified otherwise.

    Fig 1: Switch Circuit Diagram
    G05392322Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Switch connection

    This figure illustrates a complex switch. The continuity between terminals at each position is as indicated in the table below.

    CONTINUITY SPECIFICATION

    SWITCH POSITION TESTER CONNECTION SPECIFIED CONDITION
    OFF - -
    1st stage 1-5-6 Continuity
    2nd stage 1-4-6 Continuity
    3rd stage 1-3-6 Continuity
    4th stage 1-2-6 Continuity
    Fig 2: Identifying Switch Connection
    G05392323Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.