LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Body - Lancer Evolution) >> Door >> Specification(S) >> On-Vehicle Service >> Power Window Safety Mechanism Check < Driver's Side >

Power Window Safety Mechanism Check < Driver's Side >

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place an approximately 10 mm (0.39 inch) thick wood chip as shown. Then, raise the window glass.
  2. Check that the window lowers by about 150 mm (5.9 inches) when the window clamps the board. If this doesn't happen, do troubleshooting. Refer to TROUBLE SYMPTOM CHART  .
    NOTE: If the anti-trap function (safety mechanism) is activated consecutively three times or more, carry out the learning procedures of the power window fully closed position (Refer to LEARNING PROCEDURES OF THE POWER WINDOW FULLY CLOSED POSITION < DRIVER'S SIDE >  ).
    Fig 1: Checking Power Window Safety Mechanism
    G05384151Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals