LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Manual Transaxle Overhaul - Lancer Evolution) >> Sealants And Adhesives >> Surface Preparation

Surface Preparation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Thoroughly remove all substances deposited on the FIPG application surface, using a gasket scraper.

Make sure that the FIPG application surfaces is flat and smooth. Also make sure that the surface is free from oils, greases and foreign substances. Do not fail to remove old FIPG that may remain in the fastener fitting holes.

scientia non olet · About LEMON Manuals