LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Front Axle - Lancer Evolution) >> On-Vehicle Service >> Wheel Bearing End Play Check

Wheel Bearing End Play Check

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front caliper assembly and front disk brake, and retain the front caliper assembly with a wire and the like to prevent from falling (Refer to FRONT AXLE HUB ASSEMBLY  ).
  2. Set a dial gauge as shown in the figure. Move the hub in the axial direction and measure the end play.

    Limit: 0.05 mm (0.002 inch) 

  3. After checking, install the front brake disk and the front caliper assembly (Refer to FRONT AXLE HUB ASSEMBLY  ).
    Fig 1: Checking Wheel Bearing End Play
    G05376059Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals