LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Rear Axle - Lancer Evolution) >> On-Vehicle Service >> Wheel Bearing End Play Check

Wheel Bearing End Play Check

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear brake disk. (Refer to PARKING BRAKE LINING AND DRUM .)
  2. Set a dial gauge as shown in the figure. Move the rear wheel hub assembly in the axial direction and measure the looseness.

    Limit: 0.05 mm (0.002 inch) 

  3. When the looseness exceeds the limit value, replace the rear wheel hub assembly. (Refer to REAR AXLE HUB ASSEMBLY  .)
    Fig 1: Checking Wheel Bearing End Play
    G05394410Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. After checking, install the rear brake disk. (Refer to PARKING BRAKE LINING AND DRUM .)
scientia non olet · About LEMON Manuals