LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Rear Axle - Lancer Evolution) >> On-Vehicle Service >> Gear Oil Level Check >> Torque Transfer Mechanism Part

Torque Transfer Mechanism Part

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the filler plug.
    Fig 1: Identifying Filler Plug
    G05394402Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Check that the gear oil level is in between the upper limit (bottom of the oil filler plug hole) and the lower limit.
  3. If the gear oil level is not in between the upper limit and the lower limit, fill the specified gear oil to the bottom of the filler plug hole.

    Specified gear oil: DIAMOND ATF-SP III 

    Fig 2: Checking Gear Oil Level
    G05394367Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Install the filler plug, and tighten it to the specified torque.

    Tightening torque: 49 ± 10 N.m (37 ± 7 ft-lb) 

scientia non olet · About LEMON Manuals