LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Rear Axle - Lancer Evolution) >> On-Vehicle Service >> Fluid Level Check >> < When The Scan Tool Is Not Used >

< When The Scan Tool Is Not Used >

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trunk room side trim lid on the right of the trunk room.
  2. If the vehicle has been run, leave it for 90 min. or more in an ordinary temperature {10 - 30°C (50 - 86°F)} to allow the accumulator internal pressure to drop.
    NOTE: If the ambient temperature is 10°C (50°F) or less, allow more time to leave the vehicle to stand idle.
  3. Check that the oil reservoir fluid level is in between MAX and MIN.
  4. If the fluid level is not in between MAX and MIN, fill the specified fluid.

    Specified fluid: DIAMOND ATF-SP III 

    Fig 1: Identifying Oil Reservoir
    G05392277Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Install the trunk room side trim lid.
scientia non olet · About LEMON Manuals