LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Mechanical - Lancer Evolution) >> Valve Stem Seal >> Removal And Installation >> Removal Service Points >> D: Valve Spring Retainer Lock Removal

D: Valve Spring Retainer Lock Removal

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Screw in special tool MB992090 to special tool MD998772 and assemble special tool MB992089.
    CAUTION: When removing the valve spring retainer lock, leave the piston of the cylinder in the TDC (Top Dead Center) position. The valve may fall into the cylinder if the piston is not properly in the TDC position.
  2. Install special tool MD998772 (with special tools MB992090 and MB992089 attached) to the cylinder head and compress the valve spring. Then, remove the valve spring retainer lock.
    Fig 1: Identifying Special Tool MB992090 To Special Tool MD998772 And Special Tool MB992089
    G05374145Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals