LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Clutch On-Vehicle Service - Lancer Evolution) >> Clutch Pedal And Master Cylinder >> Removal And Installation >> Installation Service Points >> >> A << Clutch Tube Assembly A Connection

>> A << Clutch Tube Assembly A Connection

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • When connecting the clutch tube assembly A and clutch master cylinder, check that the O-ring and clip are not damaged.
  • If any connection areas of clutch tube assembly A and clutch master cylinder or O-ring is dirty, clean with the clutch fluid.

Assemble the clip to the clutch master cylinder. Then, connect the clutch tube assembly A to the clutch master cylinder.

Fig 1: Identifying Clutch Master Cylinder And Clutch Tube Assembly
G05393842Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals