LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Steering -- Lancer Evolution) >> Power Steering Gear Box And Linkage >> Disassembly And Reassembly >> Assembly Service Point >> >> A << Band Installation

>> A << Band Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Secure the rack housing, and firmly crimp the bellows band by the bellows band clipping tool (special tool: MB992209).
  • Crimp the bellows band securely until the special tool (MB992209) contacts the stopper.
  1. Using the special tool (MB992209), crimp the bellows band.
    Fig 1: Identifying Special Tool (MB992209)
    G05394814Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Check that the crimping width of the band (A) is within the range of the standard value.

    Standard value (A): 2.4 - 2.8 mm (0.09 - 0.11 in) 

    Fig 2: Checking Crimping Width Of Band
    G05394815Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals