Steering Wheel Voice Control Switch Continuity Check

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Use an ohmmeter to measure the resistance value between the terminal.

TESTER CONNECTION MEASUREMENT VALUE

Switch position	Tester connection	Measurement value
No push	2-3	Approximately 74 kΩ
"Speech" switch		Approximately 1.5 kΩ
"Pick-up" switch		Approximately 3.3 kΩ
"Hang-up" switch		Approximately 6.0 kΩ

Fig 1: Identifying Steering Wheel Voice Control Switches

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Checks whether there is a continuity between terminal No. 4 and 1.

TESTER CONNECTION SPECIFIED CONDITION

Tester connection	Specified condition
4 - 1	Continuity exists (2 Ω or less)

Fig 2: Identifying Steering Wheel Voice Control Switch Connector Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.